I've said it before and I'll repeat once again that people take the freedom of speech waaaay to far.
So instead of exercising in a free speech like many customers tend to do I'll yet again refer to the actual fact as they can be verified with an independent party, in this case - the eBay messaging:
You judge for yourself.
Went bad. Seller Blamed everything but his part. Ive repaired tv's for 10 years
(author's note: why do so many people write "tv's" as opposed to "TVs"? Is it really incorrect as I think it is or is it just me? Not picking on this particular buyer, I often see it written that way especially by customers claiming to be 10 or more years in the business. Either English has a set of rules that I don't know of or...well, anyway, back to the point...)
Customer correspondence as fetched from the eBay history:
Subject: Other: mainstreetpc sent a message about 6871QZH056B 6870QZH004B ZSUS BOARD *** REPAIR KIT *** #110623320783
Sent Date: Jul-23-11 09:28:53 PDT
Hi, I just wanted to let you know that this repair kit worked for about 2 days after it was installed and then blew again.
|Dear mainstreetpc, |
It does happen sometimes.
Sometimes it's because of the IC in the kit - it may be just bad. People tend to presume this as the only possible reason.
Sometimes it's the way it is being installed. I know because I've done hundreds of these myself. How do you apply the heat transfer compound. How do you fasten and what bolts do you use to fasten the heat sink. How do you solder.
Sometimes it's other components on the board that were hit during the initial shock when the first IC failed or just components (particularily the second FET) that are so worn out they just give up and damage the IPM in the aftermath of their own failure. I've seen that too and I've seen it enough times to be certain it's a failure cause on its own that has nothing to do with the IPM.
And sometimes - quite often actually after a few days pass with the baord working - it's actually the OTHER sustain board that fails and people call us and tell us that the one we repaired for them failed. I know that for a fact too since we do lots of those repairs and you can't really argue with numbers.
So yes, it can be any of the above.
if I had a firm way knowing which one it was I'd told you in advance and if I knew an IC would fail I would not have sold it.
What would you do in my place, with so many possibilities and no engineering strict way to narrow down and avoid the problem?