Thursday, July 2, 2015

Toshiba 42XV540U backlight and no image on screen repair

It's been a while since I blogged component level repair, so here's something.

A customer brought a Toshiba 42XV540U LCD TV after we've serviced the power supply PE0580A for him.

He said the TV started responding and clicking after our repair, but the display remained dark.

We agreed on returning the money for the board repair and taking the TV instead as he said he didn't want to invest more time with it.

So summarize:
TV model: Toshiba 42XV540U

Failure symptoms: TV responds to power on command, fans start turning and back light comes on (we could see from the back of the TV and a glow could be seen from the front, but only in a dark room).
We could not make the TV output sound by blindly trying to change inputs; if you know how to do it perhaps you can do it , thus eliminating the main board as a top suspect.

Solution:  The TV was responsive to on and off commands, which suggests the main board was good.
(failed main boards usually fail to do one or both of those operations). Plus backlight was coming up, which means the main board's processor was up and running to the point of activating the backlight.
On the other hand we couldn't get sound out of it.
We checked the voltage going to the T-CON board and it was there - 12V DC.

So the options were the main board (less likely), the T-CON or the video accelerator PE0578 (about equally likely) or the display itself (unlikely, it rarely ever fails to all dark screen).

Luckily it turned out we had eBay listings for both the T-CON and the accelerator board.

Testing with them it turned out the problem was in the accelerator board PE0578.

Knowing that we've put the bad and the good one side by side and started hunting:



Found the problem in the voltage stabilizer from 12V to 3.3V.
As you can see there was a significantly lower resistance there and, more importantly, it was the same in both directions on the bad board:


On the good board it was a good diode read - 0.5 - 0.6 kOhm in one direction and infinite or very high in the other:

(The measurement can be made on several points and there are several components there that could be causing it; there were a few inductors we removed in order to eliminate the circuits after that as well as a few diodes that were in parallel and could have been causing the shortage).

The only passive component we found to have been bad was diode  D592 on the back of the board. It was fairly well shorted, having about 4-5 Ohm in both directions:



Used generic diode for replacement, such as the ones used in our repair kits for BN44-00161A power supply. Almost any diode will likely do, including even zener diodes (assuming it's properly soldered in regards to its polarity, of course).

Long story short, we traced it down to the actual DC converter/stabilizer IC (AOZ1017AI).

But since we didn't have a replacement handy and our US vendor didn't have it either (had to ether use another US vendor or our Asian vendor), we took matter in our hands and just hacked a stabilizer of our own:



The solution worked out well and the TV is presently operational.

While I don't give out everything I hope this helps someone save a buck or two :-)

Good luck!

1 comments:

Anonymous said...

DuckyLuck is a premium casino web site with a handful of strong video poker games. Find well-liked options like Deuces Wild, Tens or Better, and Aces and Faces, several of} with multi-hand options. Decide how much you 바카라사이트 plan on spending before you start playing in} video poker. If you’re new to video poker, start small by on the lookout for the lowest denomination machines. Set a finances of how much you wish to wager – and persist with it .

Post a Comment